EmailEmail  PrintPrint  a a a

Capabilities

With our full in-house, CAD/CAM design facilities, we are able to assist customers in the development of products to meet specific requirements. Our facility benefits from the ability to draw on over 36 years of first hand experience in the characteristics and properties of the materials being used resulting in practical and workable solutions to customers problems.

C&S Machine Co. is just more than a CNC, Plasma, and Welding fabrication shop, we are also an all-purpose job shop. We offer many services that you may not be aware about. Below is a list of our services that may help you.

 

Machine Shop

  • In our facility of 20,000 square feet, we are equipped with 15 Engine Lathes, which have machining capabilities of up to 48' diameter and lengths up to 20 feet.
  • 1 - 48'" Vertical Boring Machine
  • 4 -  Bridgeport Vertical Mills
  • 2 - #3 Horizontal Mills
  • 3 - #4 Vertical Mills
  • 3 - Metal Saws up to 18 rounds
  • 1 - Jig Bore Mill
  • 1 - 12' Planer
  • 1 - Key Seating Machine with 1' capacity
  • 3 - Radial Drill Press
  • 1 - Vertical Machining Center - 3 Axis

Plasma

  •  1 - 100 Amp Esab Plasma/OxyFuel machine with a 6'X12' cutting board capability
  • 1 - 200 Amp Esab Plasma machine with a 10'X12' cutting board capability

Waterjet

  • 2004 Flow Flying Bridge Waterjet Model 6012
  • Dynamic Waterjet increases speed and reduces taper
  • Three-sided load capability; with four-sided operator access
  • Uniquely designed which minimizes footprint by integrating pump into the backside of the machine frame, allowing all facets of machine to be controlled by roll-around control.
  • Paser Abrasivejet cutting systems
  • CUTTING TABLE SIZE :6' x 12'
    TRAVELS:
    X AXIS: 72"
    Y AXIS: 144"
    Z AXIS: 8"
  • MAIN MOTOR: 50 H.P., 460 VOLTS
  • CUTTING SPEED RANGES: 0-300 IPM

Multiple Axis CNC Press 

  • "Rocker Arm" design
  • Powered Ram Tilt
  • High Accuracy Hydraulics
  • Dual Ram feedback
  • 250 Ton Max
  • 12 ft. bed

 Grinding Department

  • 3 - Surface Grinders
  • 1 - Rockwell Hardness Tester
  • 1 - Drill Sharpener

Heat Treating Department

  • 2 - Heat Treating Ovens

Balancing Department

  • 1 - Electronic Balancing Machine

Auxillary Equipment Department

  • 1 - 100 Ton Hydraulic Press
  • 1 - 5 Ton Bench Press
  • 1 - 150 Ton Vertical Press
  • 5 - Stand Grinders

Baler and Compacter Repair Department

  • We provide on site service and repair of balers and commercial compactors
  • We also install new compactors

Repair Service

  • We offer a wide variety of repair and complete rebuilding service

Drive Shaft Repair

  • One of our specialties is the repair of auto and truck drive shafts. We have an extensive stock of new parts available.

 

nimblecmsan NTS product